 |
Surface Grinding and PolishingCLICK HERE to e mail your Drawings or Hard Chrome Plating, Grinding & Polishing Enquiries. Surface Grinding
Our Lumsden Segmental Grinding Machines are capable
of handling plates, castings and pre-machined components of
formidable sizes to close tolerances, as well as offering value
for money on smaller components. Stock removal is typically
2 to 5mm, but our machines can remove material at such a rate
that conventional machining can not compete in some circumstances.
The largest machine in this department has a 2540mm diameter
magnetic chuck. 100 inch Lumsden refurbished Feb 2009.
A range of cylindrical grinding machines, all fitted with coated
abrasive polishing units, enable us to grind up to a length
of 6.1 metres. With a maximum diameter of 1066mm a whole
host of components can be accommodated. Surface finishes down
to 0.05microns can be achieved. We have a lifting capacity of
10,000kgs in this area.
With a swing of up to 760mm we can grind outside and inside
diameters, faces and angles on intricate components.
Again, Our capacity is formidable. With both chucking and planetary
machines even the most awkward bores can be ground and polished.
We can polish anything we can grind! Flats, edges,
all to a mirror finish if required. We also specialise in polishing
flat plates to mirror finishes for the leading catering equipment
manufacturers.
|
